What the RockSim (a rocket simulator software package) model looks like. I've got an H128 installed for a motor.
Viewed: 760 times.
|
RockSim Screen shot showing motor combinations and altitudes.
Viewed: 561 times.
|
Tube after being covered with 1 layer of pantyhose and 3 layers of polycrylic
Viewed: 622 times.
|
Another close up of the Tube after "quasi-glassing"
Viewed: 555 times.
|
Fin Slot area after "quasi-glassing"
Viewed: 524 times.
|
Full length BT View
Viewed: 482 times.
|
Close up of the lower fins, notice CR slot and white glue splotch from paper outline... I didn't have any rubber cement :(
Viewed: 495 times.
|
Upper fin after being cut out and sanded. I'm using the Estes Fin pattern with tabs to make up for the CG/CP relationship issues
Viewed: 522 times.
|
Both FWD and AFT Fins
Viewed: 511 times.
|
Hopefully what the Phoenix will look like when glued together and ready for paint. All just dry fit for this picture
Viewed: 524 times.
|
MMT ready to be installed. Notice the "poor mans" baffle. Simply add 1/2 of a Chore Boy and poof done.
Viewed: 510 times.
|
MMT installed with only top CR epoxied. FWD fins installed with 5min epoxy. Now what to do for the filets... Hmm.
Viewed: 511 times.
|
FWD Fins installed with 5min epoxy. Notice the bevel. I didn't get it exactly right. I wanted a more shallow bevel on the edges and a deeper one on the front of both FWD and AFT fins. Oh well.
Viewed: 524 times.
|
Bottom CR dry installed for alignment and to keep the MMT rigid during fin installation. This design will have 4 CR's, each fin set will be sandwiched between a pair
Viewed: 491 times.
|
Fin Can getting inside and out filets and ready for foam. I only used a top and a botton CR, foam will do the rest
Viewed: 586 times.
|
Fins are perm now, with some fillnfinish to smooth out the bevel marks
Viewed: 547 times.
|
