|
|
Baby Nuk Motor Options
Viewed: 351 times.
|
Flight Profile of Baby Nuk on a M1350 AMW White Wolf motor
Viewed: 335 times.
|
Electronics wiring
Viewed: 323 times.
|
Getting ready to start assembling the MMT. It's 30" long in 3" PML Phenolic
Viewed: 384 times.
|
Three CR's will do the alignment duty. These are 3/8" 7 ply Plywood cut with a rotating circle cutting in a drill press.
Viewed: 373 times.
|
The Body Tube. For some reason I ended up with a 48" long piece of 5.5 LOC tubing. As soon as I get fin slots cut and the altimeter bay opening cut in it. It's going to get 1 wrap of 6oz Carbon fiber satin weave and 1 wrap of 3oz Satin weave Fiberglass
Viewed: 370 times.
|
Doing duty as the NC is a Performance Rocketry 19" long.
Viewed: 356 times.
|
Nose Cone getting some Bondo glazing putty where the seam doesn't fit. It will take a few passes I'm sure. Also a few other areas need a little touchup
Viewed: 361 times.
|
Top CR, set back from the top of the MMT 3/8 of an inch. Filets on both sides with West Systems and cabosil
Viewed: 357 times.
|
Other side of the top CR with Filet
Viewed: 379 times.
|
Shot with both filets visible
Viewed: 363 times.
|
Middle CR. Top side with filet showing. Bottom side will get filet later once fins are in. Each CR is put on with a coat of Epoxy *neat*. Then cabosil is added to get a thicker consistency. And is then spread with a tongue depressor
Viewed: 368 times.
|
Full length view after top two CR's have been attached. Ready for Fins and that part of the construction
Viewed: 347 times.
|
Ah, yes, the Fins. Made from McMaster Carr .125 (1/8") G10 Garolite. Printed the template from RockSim and taped it together. Dimensions are 15" root, 7" span. They will be attached to the MMT with epoxy and a full width batch of carbon fiber from fin to fin.
Viewed: 351 times.
|
Fins all cut ready for sanding to final shape. Most likely they will be drilled and bolted together for sanding. All the root edges were square from original sheet cut.
Viewed: 366 times.
|
