HyperLoc 835 Altitudes *

HyperLoc 835 Design Layout *

These are all the parts that come with the LOC kit. One thing I need to do is show you how heave this BT is, it's something different that most the LOC stuff. *

Another view of all the goodies.... Yes, it comes complete with the Altimeter bay *

Bottom - actually top CR of the 27" long 54mm MMT tube. Remember, this rocket will support the 54mm 835 Hypertek tank *

No, this isn't my minimum diameter rocket, it's the 54mm MMT tube for the HyperLoc 835... with one, the top CR curing out. *

54mm MMT tube turned right side up and the fillet curing on that side. Also will be glazed later. *

Ya can't build like the instructions say. This rocket uses CR's on the MMT, and this this ring that actually goes above the top of the MMT and is the shock cord attachment point. I'll glaze if for strength after this cures. *

Bottom Side will be glazed as well. You can see, I already did the whole in the middle. Can't forget that! *

Glazed on the outsides and curing *

The typical LOC altimeter bay. Actually, they are pretty good and you can see the STIFFY (yes this is a public channel), in the parts picture. One of the shock cord attach points curing out. *

Bottom of shockcord mount epoxied up *

The shockcord attach point on one side of the ebay. *

A shot with no flash, I'll glaze these top and bottom as well. Again, when you build, dont forget to glase the inside of the holes. *

Bottom of other ebay shockcord mount epoxied *

STIFFY glued in and centered, you can see the overlap so the bulkheads will fit in. *