The following pre-flight checklist has been prepared. 
 - Load 2 ejections charges for drogue/Pilot - 2g (2 scoops)
 - Load 2 ejections charges for tether - .2g
 - assemble tether and tape and attach to lower retention u-bolt
 - fish ejectionwires down to holes for altimeters and silly putty and tape opening  s
 - Check main parachute bridle connections to nose cone and main airframe 
 - Pack main recovery system
 - place main protection shield
 - lay apogee event charges on top of Main protection
 - place apogee protection shield
 - Check drogue parachute bridle connections to motor section and main airframe 
 - Pack drogue recovery system and install Nose Cone
 - Replace batteries and test altimeters 
 - fish power wires thru vent hole
 - Install altimeters into payload bays
 - Wire electric matches to altimeters
 - Install retaining screws for altimeter bays 
 - Build AMW 76mm M1350WW reload as per instructions 
 - Install motor into rocket with retainer 
 - Prepare igniter and make sure it will fit into motor 
 - Tape igniter to airframe 
 - Check in with RSO, turn in flight card 
 - Load onto Rail
 - Turn on Perfectflite #1 and verify continuity (three beeps)
 - Turn on Perfectflite #2 and verify continuity (three beeps)
 - wrap power wires with tape and push back thru vent hole
 - Install igniter, connect to launch system and verify continuity 
 - Return behind flight line 
 - Get camera and wait for launch